E' uscita la versione 2.4.6
Gli aggiornamenti riguardano:
* documentation: various improvements
* estop_latch: make watchdog behavior match documentation.
* hostmot2: make gpio pins behave when the value of the pin as an integer was not 0 or 1
* iocontrol: fix current tool information after reloading table
* near: fix for negative inputs
* pico/7i43/pluto: if the kernel does not report a base_hi address, make an educated guess (fixes the D510MO bug)
* pico/7i43/pluto: show "linux parport does not support mode" as a warning, not an error
* pncconf: fix spinbox limits on metric configurations
* pncconf: fix jogging buttons on lathe configs
* pncconf: add touchy gui choice
* pncconf: fix spindle-at-speed code
* pncconf: fix launchers on ubuntu 10.04
* pncconf: fix firmware directory names for 7i43, 5i22
* sample configs: add another smithy sample configuration
* stepconf: fix launchers on ubuntu 10.04
* touchy: fix display of 3-digit active gcodes
Sono disponibili anche le versioni beta della 2.5 (anche in modalità simulazione e 64 bit) a questo link
http://emc2-buildbot.colorado.edu/~buildmaster/