Promette di poter stampare sia PLA che ABS
Quanlcuno l'ha provato?? sembra interessante,non sarebbe male eliminare per sempre i problemi di aderenza del primo layer.....
Pensavo che non servisse il riscaldamento del piatto(cosi dicono alcuni forum),ma leggendo bene sul loro sito ho notato che consigliano il riscaldamento
PLA @ normal PLA settings
ABS @ normal ABS settings (heated bed at least 100C-110C recommended)
Laybrick @ normal PLA settings
Wood filament @ normal PLA settings
HIPS @ normal ABS settings (heated bed at least 100C-110 recommended)
PET+ @ normal PLA settings
http://www.buildtak.eu/
https://www.youtube.com/watch?v=IP14DQQShfc
https://www.youtube.com/watch?v=t9NLyjJcyJk
https://www.youtube.com/watch?v=uSl1N3xXunk
Guida di installazione
https://www.youtube.com/watch?v=qPobZj10AnY