da poco sperimento l'uso di una CNC autocostruita, alla quale ho applicato un inverter YL600 per la gestione del router.
Per diversi giorni tutto ha funzionato senza problemi con i parametri standard (non ho cambiato nulla), ma proprio oggi dopo aver fatto una semplice lavorazione ho spento il motore della fresa, ho messo il nuovo pezzo di tavola ed acceso nuovamente il motore.
Un accenno all'avvio (si sente all'interno qualcosa che si sta avviando ma non gira fisicamente il mandrino) e sul display appare il messaggio: Error 04.
Consultando il manuale all'errore trovo che:
When the motor is running, fault in the internal power component module of the converter occurs:
1 The acceleration and deceleration time is set too short;
2 the over current and overheating of the converter, please check whether the motor is short circuited, and the machine load too large;
3 the input voltage is too high/low, or the input voltage fluctuates substantially;
4 The converter does not match the motor power, or foult in Wye-Delta
5 improper setting of DC injection brake parameters
6 improper setting of VF parameters
7 The cooling fan is demaged or in locked rotor, the converter cooling is not good
8 gate driving voltage of powef components is too high or too low, which needs reparing
Ho provato a cambiare qualche parametro... ma nulla!
QUalcuno di voi si è imbattuto in un simile problema?
Grazie