Dall' anno scorso possiedo una macchina cnc con il controller Fagor 8025.
Mi sono fatto mandare il manuale di installazione direttamente dalla fagor.
Ho veramente bisogno di un aiuto per il backup dei parametri macchina, perchè la batteria del controller non so quanto regga e non riesco a capire come effettuare il backup dei parametri.
La macchina ha una seriale. Secondo voi tramite winDNC si possono effettuare backup dei parametri macchina?
Nel manuale non c'è scritto niente, ed anche se volessi farmi degli screenshot dei parametri tramite telefono non si capisce cosa intendano con questa frase:
Io no riesco a capire se la mia macchian possiede un PLC integrato e non vorrei fare danni..To lock or unlock access to machine parameters, decoded "M" function table and to
the leadscrew error compensation tables, proceed as follows:
* Press the [OP MODE] key.
* Press [6] to select the Editing mode.
* Press the softkey for [LOCK/UNLOCK]. The screen will show the word: "CODE:"
(password).
* Key in "PKJIY" and press [ENTER] to lock the access or key in "PKJIN" and
press [ENTER] to unlock the access.
When access to machine parameters is locked, only those regarding serial line
communications via RS232C may be changed.
CAUTION when using a CNC with an integrated PLC (CNC+PLCI)
When using this access locking code, the machine parameters, the decoded "M"
function table and the leadscrew error compensation tables are stored in EEPROM
memory.
When using the access unlocking code, it recovers these previously stored tables
from the EEPROM memory.
Therefore, one must be careful and lock these tables before unlocking them.
Otherwise, the factory set values or other prelocked values, may be restored overwriting
the ones the manufacturer entered but did not lock.
To access the machine parameter table via keyboard, press the following keystroke
sequence:
[OP MODE] Shows the various operating modes
[9] Special modes
[1] General parameters
Qualcuno è cosi' gentile da aiutarmi?
Grazie mille.